Board-level diagnostics and repair of inverter midwall and multi-split systems that trip, short-cycle or stop cooling. In Melrose Arch this is sandton prime work on inverter split systems, attended within about 40 minutes of dispatch.We work across every major brand installed in Melrose Arch, and diagnostics start from the plated design data rather than a guess.A technician is dispatched on the next available slot, day or night, with a stocked vehicle so most faults are closed out on the first visit.Precinct management controls contractor access and lift bookings. Aircon Repairs & Servicing bookings in Melrose Arch are logged against Block 6 so we can allow for power availability on site.
- Typical response window
- 40 minutes from Sandton
- Distance from Sandton CBD
- 4.9 km
- Municipal water hardness
- moderate (135 ppm)
- Load-shedding schedule
- Block 6
- Access & compliance
- Precinct management controls contractor access and lift bookings.
- Typical installed systems
- High-density mixed use: VRV/VRF, restaurant refrigeration and coldrooms.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R410a | HFC blend (A1) | 280-320 kPa at 7 degrees C evaporating | 2 600-3 000 kPa at 45 degrees C ambient | Most inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005. |
| R32 | HFC (A2L, mildly flammable) | 300-340 kPa at 7 degrees C evaporating | 2 700-3 100 kPa at 45 degrees C ambient | Current-generation inverter splits and heat pumps. |
Common questions
How fast can you get to me?
Emergency callouts are dispatched to the next available technician, with the arrival window confirmed by SMS when the vehicle leaves.
Can you work after trading hours?
Yes. Retail, restaurant and office work is routinely scheduled at night or early morning under a permit-to-work so trading is not interrupted.
Is a compressor replacement guaranteed?
Yes. Replacements are done with a system flush and new drier, and both part and workmanship are warranted, provided the original cause of failure is corrected.
Do you top up gas without finding the leak?
No. A weighed charge into a leaking system is money out the window, so the leak is found and repaired first, then the system is evacuated and charged to the plated weight.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.