Full preventative service: coil clean, filter replacement, drain flush, gas pressure check and electrical torque test. In Sunninghill this is luxury gated estates work on midwall split systems, attended within about 55 minutes of dispatch.On Midea equipment specifically — value inverter splits, cassettes and hot water heat pumps — the faults we see most in Sunninghill are outdoor fan capacitor failure and controller communication faults.Every visit starts with a full diagnostic and a written quote before any part is fitted.Office park and residential mix; complexes need body corporate clearance. Aircon Repairs & Servicing bookings in Sunninghill are logged against Block 11 so we can allow for power availability on site.
- Typical response window
- 55 minutes from Fourways & Northern Suburbs
- Distance from Sandton CBD
- 9.6 km
- Municipal water hardness
- moderate (165 ppm)
- Load-shedding schedule
- Block 11
- Access & compliance
- Office park and residential mix; complexes need body corporate clearance.
- Typical installed systems
- Townhouses and offices with midwall splits and light commercial HVAC.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R410a | HFC blend (A1) | 280-320 kPa at 7 degrees C evaporating | 2 600-3 000 kPa at 45 degrees C ambient | Most inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005. |
| R32 | HFC (A2L, mildly flammable) | 300-340 kPa at 7 degrees C evaporating | 2 700-3 100 kPa at 45 degrees C ambient | Current-generation inverter splits and heat pumps. |
| R22 | HCFC (phased out) | 480-520 kPa at 7 degrees C evaporating | 1 700-2 000 kPa at 45 degrees C ambient | Legacy splits and ducted plant installed before the phase-out. |
Common questions
My Midea unit heats but will not cool. What is wrong in Sunninghill?
That points to the four-way reversing valve sticking or its solenoid coil failing. It can often be freed and the coil replaced without opening the sealed system.
Do you charge a callout fee?
A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.
My ice machine runs but makes no ice, is it worth repairing?
Usually yes. The four common causes (water inlet valve, water pump, scaled evaporator and a stalled harvest cycle) are all repairable at a fraction of replacement cost. We quote in writing after the diagnostic and tell you honestly when a machine is past economic repair.
Why is my ice cloudy or melting too fast?
Cloudy, soft ice means the freeze cycle is being cut short or the water is carrying too many dissolved solids. We test hardness and TDS on site, fit the right filtration, descale the plate and re-time the cycle so cubes freeze clear and hard.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.