Ice machine re-gassing with proper leak detection first: we find and fix the leak, then weigh in a fresh charge rather than topping up. In Waterfall Corner this is corporate & commercial work on sealed refrigeration system systems, attended within about 55 minutes of dispatch.On KIC equipment specifically — domestic fridges, freezers and chest units — the faults we see most in Waterfall Corner are thermostat failure and door seal perishing.Every visit starts with a full diagnostic and a written quote before any part is fitted.Centre management contractor booking. Ice Machine Repairs bookings in Waterfall Corner are logged against Block 15 so we can allow for power availability on site.
- Typical response window
- 55 minutes from Midrand & Waterfall Corridor
- Distance from Sandton CBD
- 13.9 km
- Municipal water hardness
- hard (180 ppm)
- Load-shedding schedule
- Block 15
- Access & compliance
- Centre management contractor booking.
- Typical installed systems
- Restaurant and retail refrigeration with packaged HVAC.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R134a | HFC (A1) | 80-140 kPa at -5 degrees C evaporating | 900-1 200 kPa at 45 degrees C ambient | Wine cellars, display cabinets, medium-temperature commercial refrigeration and some heat pumps. |
| R404A | HFC blend (near-azeotropic) | 40-60 kPa (approx. 2-4 bar) | 1500-1900 kPa | Older commercial ice machines, cube makers, ice bins and blast chillers |
| R448A | HFO/HFC blend (low GWP) | 50-75 kPa | 1600-2000 kPa | Modern commercial ice machines, cube and flake units, coldroom retrofits |
| R290 (propane) | Natural hydrocarbon (A3 flammable) | 30-50 kPa | 1000-1400 kPa | Undercounter and self-contained ice makers, nugget machines, back-bar units |
Common questions
How long should a KIC fridge last in Waterfall Corner?
With a clean condenser and a sound door seal, twelve to fifteen years is normal. Most callouts we attend are thermostats, start relays and perished seals rather than sealed system failures.
Can you just top up the gas in my ice machine?
No: a machine low on refrigerant has a leak, and topping up hides it. We leak-trace electronically and under nitrogen, repair the joint, fit a new drier, pull a deep vacuum and weigh in the exact plated charge.
Can you work after trading hours?
Yes. Retail, restaurant and office work is routinely scheduled at night or early morning under a permit-to-work so trading is not interrupted.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.