Water filter, inlet valve and solenoid replacement, the single most common cause of poor ice quality and low output on hard-water supplies. In Waterfall Corner this is corporate & commercial work on water supply side systems, attended within about 55 minutes of dispatch.We work across every major brand installed in Waterfall Corner, and diagnostics start from the plated design data rather than a guess.Every visit starts with a full diagnostic and a written quote before any part is fitted.Centre management contractor booking. Ice Machine Repairs bookings in Waterfall Corner are logged against Block 15 so we can allow for power availability on site.
- Typical response window
- 55 minutes from Midrand & Waterfall Corridor
- Distance from Sandton CBD
- 13.9 km
- Municipal water hardness
- hard (180 ppm)
- Load-shedding schedule
- Block 15
- Access & compliance
- Centre management contractor booking.
- Typical installed systems
- Restaurant and retail refrigeration with packaged HVAC.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R134a | HFC (A1) | 80-140 kPa at -5 degrees C evaporating | 900-1 200 kPa at 45 degrees C ambient | Wine cellars, display cabinets, medium-temperature commercial refrigeration and some heat pumps. |
| R448A | HFO/HFC blend (low GWP) | 50-75 kPa | 1600-2000 kPa | Modern commercial ice machines, cube and flake units, coldroom retrofits |
Common questions
Can you work after trading hours?
Yes. Retail, restaurant and office work is routinely scheduled at night or early morning under a permit-to-work so trading is not interrupted.
Why is my ice cloudy or melting too fast?
Cloudy, soft ice means the freeze cycle is being cut short or the water is carrying too many dissolved solids. We test hardness and TDS on site, fit the right filtration, descale the plate and re-time the cycle so cubes freeze clear and hard.
Is scale really a problem for ice machines here?
Yes, it is the single biggest cause of lost output on this water supply. Scale insulates the evaporator, so the machine runs longer for less ice and eventually pits the plate. Regular descaling is far cheaper than an evaporator replacement.
There is water on the floor under my ice machine, can you find the leak?
We trace it wet rather than guessing: inlet valve weep, split distribution tube, blocked machine drain or a backed-up bin drain all present the same way. The water side is pressure-tested before we recommission.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.