Fixed-schedule maintenance contracts with priority breakdown response, filter changes and hygiene records for venues that cannot trade without ice. In Dunkeld this is sandton prime work on planned maintenance systems, attended within about 50 minutes of dispatch.On Sub-Zero equipment specifically — built-in refrigeration columns, wine storage and integrated units — the faults we see most in Dunkeld are control board and sensor faults and condenser fouling behind grille.Every visit starts with a full diagnostic and a written quote before any part is fitted.Heritage overlays on some streets restrict visible external plant. Ice Machine Repairs bookings in Dunkeld are logged against Block 6 so we can allow for power availability on site.
- Typical response window
- 50 minutes from Sandton
- Distance from Sandton CBD
- 4.6 km
- Municipal water hardness
- moderate (130 ppm)
- Load-shedding schedule
- Block 6
- Access & compliance
- Heritage overlays on some streets restrict visible external plant.
- Typical installed systems
- Older character homes retrofitted with concealed multi-split systems.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R134a | HFC (A1) | 80-140 kPa at -5 degrees C evaporating | 900-1 200 kPa at 45 degrees C ambient | Wine cellars, display cabinets, medium-temperature commercial refrigeration and some heat pumps. |
| R404A | HFC blend (near-azeotropic) | 40-60 kPa (approx. 2-4 bar) | 1500-1900 kPa | Older commercial ice machines, cube makers, ice bins and blast chillers |
| R448A | HFO/HFC blend (low GWP) | 50-75 kPa | 1600-2000 kPa | Modern commercial ice machines, cube and flake units, coldroom retrofits |
Common questions
Can a built-in Sub-Zero be repaired without removing the joinery in Dunkeld?
In most cases yes. The units are designed to be serviced from the front through the grille and toe panel; full de-racking is only needed for sealed system work.
Do you charge a callout fee?
A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.
My ice machine runs but makes no ice, is it worth repairing?
Usually yes. The four common causes (water inlet valve, water pump, scaled evaporator and a stalled harvest cycle) are all repairable at a fraction of replacement cost. We quote in writing after the diagnostic and tell you honestly when a machine is past economic repair.
Why is my ice cloudy or melting too fast?
Cloudy, soft ice means the freeze cycle is being cut short or the water is carrying too many dissolved solids. We test hardness and TDS on site, fit the right filtration, descale the plate and re-time the cycle so cubes freeze clear and hard.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.