Water pump and distribution replacement for machines with weak spray patterns, hollow cubes or no fill across the plate. In Witkoppen this is luxury gated estates work on water circulation systems, attended within about 65 minutes of dispatch.On Manitowoc equipment specifically — modular cube ice machines and bins for high-volume hospitality sites — the faults we see most in Witkoppen are curtain switch not registering and condenser fan motor failure.Every visit starts with a full diagnostic and a written quote before any part is fitted.Mixed access; some sections open, some boomed. Ice Machine Repairs bookings in Witkoppen are logged against Block 12 so we can allow for power availability on site.
- Typical response window
- 65 minutes from Fourways & Northern Suburbs
- Distance from Sandton CBD
- 13.6 km
- Municipal water hardness
- hard (190 ppm)
- Load-shedding schedule
- Block 12
- Access & compliance
- Mixed access; some sections open, some boomed.
- Typical installed systems
- Family homes and small commercial premises.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R134a | HFC (A1) | 80-140 kPa at -5 degrees C evaporating | 900-1 200 kPa at 45 degrees C ambient | Wine cellars, display cabinets, medium-temperature commercial refrigeration and some heat pumps. |
| R448A | HFO/HFC blend (low GWP) | 50-75 kPa | 1600-2000 kPa | Modern commercial ice machines, cube and flake units, coldroom retrofits |
Common questions
Why does my Manitowoc show a long harvest cycle fault
A long harvest fault points at the hot-gas valve, harvest probe or a curtain switch that is not resetting. We verify head pressure during harvest before condemning any part.
Do you charge a callout fee?
A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.
Why is my ice cloudy or melting too fast?
Cloudy, soft ice means the freeze cycle is being cut short or the water is carrying too many dissolved solids. We test hardness and TDS on site, fit the right filtration, descale the plate and re-time the cycle so cubes freeze clear and hard.
Is scale really a problem for ice machines here?
Yes, it is the single biggest cause of lost output on this water supply. Scale insulates the evaporator, so the machine runs longer for less ice and eventually pits the plate. Regular descaling is far cheaper than an evaporator replacement.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.