Ice machine re-gassing with proper leak detection first: we find and fix the leak, then weigh in a fresh charge rather than topping up. In Witkoppen this is luxury gated estates work on sealed refrigeration system systems, attended within about 65 minutes of dispatch.On KIC equipment specifically — domestic fridges, freezers and chest units — the faults we see most in Witkoppen are start relay and overload failure and thermostat failure.Every visit starts with a full diagnostic and a written quote before any part is fitted.Mixed access; some sections open, some boomed. Ice Machine Repairs bookings in Witkoppen are logged against Block 12 so we can allow for power availability on site.
- Typical response window
- 65 minutes from Fourways & Northern Suburbs
- Distance from Sandton CBD
- 13.6 km
- Municipal water hardness
- hard (190 ppm)
- Load-shedding schedule
- Block 12
- Access & compliance
- Mixed access; some sections open, some boomed.
- Typical installed systems
- Family homes and small commercial premises.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R134a | HFC (A1) | 80-140 kPa at -5 degrees C evaporating | 900-1 200 kPa at 45 degrees C ambient | Wine cellars, display cabinets, medium-temperature commercial refrigeration and some heat pumps. |
| R404A | HFC blend (near-azeotropic) | 40-60 kPa (approx. 2-4 bar) | 1500-1900 kPa | Older commercial ice machines, cube makers, ice bins and blast chillers |
| R448A | HFO/HFC blend (low GWP) | 50-75 kPa | 1600-2000 kPa | Modern commercial ice machines, cube and flake units, coldroom retrofits |
| R290 (propane) | Natural hydrocarbon (A3 flammable) | 30-50 kPa | 1000-1400 kPa | Undercounter and self-contained ice makers, nugget machines, back-bar units |
Common questions
How long should a KIC fridge last in Witkoppen?
With a clean condenser and a sound door seal, twelve to fifteen years is normal. Most callouts we attend are thermostats, start relays and perished seals rather than sealed system failures.
Can you just top up the gas in my ice machine?
No: a machine low on refrigerant has a leak, and topping up hides it. We leak-trace electronically and under nitrogen, repair the joint, fit a new drier, pull a deep vacuum and weigh in the exact plated charge.
Do you charge a callout fee?
A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.