Ice machine re-gassing with proper leak detection first: we find and fix the leak, then weigh in a fresh charge rather than topping up. In Chartwell this is luxury gated estates work on sealed refrigeration system systems, attended within about 80 minutes of dispatch.On Samsung equipment specifically — wind-free splits, dvm s vrf and side-by-side refrigeration — the faults we see most in Chartwell are digital inverter compressor start failure and ice build-up on evaporator in french-door fridges.Every visit starts with a full diagnostic and a written quote before any part is fitted.Smallholdings with long driveways; borehole water common. Ice Machine Repairs bookings in Chartwell are logged against Block 14 so we can allow for power availability on site.
- Typical response window
- 80 minutes from Fourways & Northern Suburbs
- Distance from Sandton CBD
- 18.5 km
- Municipal water hardness
- hard (205 ppm)
- Load-shedding schedule
- Block 14
- Access & compliance
- Smallholdings with long driveways; borehole water common.
- Typical installed systems
- Smallholdings with multiple standalone systems and borehole-fed hot water.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R134a | HFC (A1) | 80-140 kPa at -5 degrees C evaporating | 900-1 200 kPa at 45 degrees C ambient | Wine cellars, display cabinets, medium-temperature commercial refrigeration and some heat pumps. |
| R404A | HFC blend (near-azeotropic) | 40-60 kPa (approx. 2-4 bar) | 1500-1900 kPa | Older commercial ice machines, cube makers, ice bins and blast chillers |
| R448A | HFO/HFC blend (low GWP) | 50-75 kPa | 1600-2000 kPa | Modern commercial ice machines, cube and flake units, coldroom retrofits |
| R290 (propane) | Natural hydrocarbon (A3 flammable) | 30-50 kPa | 1000-1400 kPa | Undercounter and self-contained ice makers, nugget machines, back-bar units |
Common questions
What does an E1 or E4 error mean on a Samsung aircon in Chartwell?
E1 is a room temperature sensor error and E4 is an evaporator sensor error. Both are usually a failed thermistor or a connector that has corroded on the indoor board, and both are inexpensive parts once the correct one is identified.
Can you just top up the gas in my ice machine?
No: a machine low on refrigerant has a leak, and topping up hides it. We leak-trace electronically and under nitrogen, repair the joint, fit a new drier, pull a deep vacuum and weigh in the exact plated charge.
Do you charge a callout fee?
A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.