Water filter, inlet valve and solenoid replacement, the single most common cause of poor ice quality and low output on hard-water supplies. In Chartwell this is luxury gated estates work on water supply side systems, attended within about 80 minutes of dispatch.On KIC equipment specifically — domestic fridges, freezers and chest units — the faults we see most in Chartwell are start relay and overload failure and thermostat failure.Every visit starts with a full diagnostic and a written quote before any part is fitted.Smallholdings with long driveways; borehole water common. Ice Machine Repairs bookings in Chartwell are logged against Block 14 so we can allow for power availability on site.
- Typical response window
- 80 minutes from Fourways & Northern Suburbs
- Distance from Sandton CBD
- 18.5 km
- Municipal water hardness
- hard (205 ppm)
- Load-shedding schedule
- Block 14
- Access & compliance
- Smallholdings with long driveways; borehole water common.
- Typical installed systems
- Smallholdings with multiple standalone systems and borehole-fed hot water.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R134a | HFC (A1) | 80-140 kPa at -5 degrees C evaporating | 900-1 200 kPa at 45 degrees C ambient | Wine cellars, display cabinets, medium-temperature commercial refrigeration and some heat pumps. |
| R448A | HFO/HFC blend (low GWP) | 50-75 kPa | 1600-2000 kPa | Modern commercial ice machines, cube and flake units, coldroom retrofits |
Common questions
How long should a KIC fridge last in Chartwell?
With a clean condenser and a sound door seal, twelve to fifteen years is normal. Most callouts we attend are thermostats, start relays and perished seals rather than sealed system failures.
Do you charge a callout fee?
A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.
Is scale really a problem for ice machines here?
Yes, it is the single biggest cause of lost output on this water supply. Scale insulates the evaporator, so the machine runs longer for less ice and eventually pits the plate. Regular descaling is far cheaper than an evaporator replacement.
There is water on the floor under my ice machine, can you find the leak?
We trace it wet rather than guessing: inlet valve weep, split distribution tube, blocked machine drain or a backed-up bin drain all present the same way. The water side is pressure-tested before we recommission.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.