Flake and nugget ice machine repair on auger-driven units used for seafood displays, bars, spas and medical rooms, where a seized auger or worn gearbox stops output. In Broadacres this is luxury gated estates work on auger-driven flake and nugget ice systems, attended within about 70 minutes of dispatch.On Sub-Zero equipment specifically — built-in refrigeration columns, wine storage and integrated units — the faults we see most in Broadacres are control board and sensor faults and condenser fouling behind grille.Every visit starts with a full diagnostic and a written quote before any part is fitted.Estate and complex access with pre-booking. Ice Machine Repairs bookings in Broadacres are logged against Block 13 so we can allow for power availability on site.
- Typical response window
- 70 minutes from Fourways & Northern Suburbs
- Distance from Sandton CBD
- 16.2 km
- Municipal water hardness
- hard (195 ppm)
- Load-shedding schedule
- Block 13
- Access & compliance
- Estate and complex access with pre-booking.
- Typical installed systems
- Estate homes with ducted plant.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R404A | HFC blend (near-azeotropic) | 40-60 kPa (approx. 2-4 bar) | 1500-1900 kPa | Older commercial ice machines, cube makers, ice bins and blast chillers |
| R448A | HFO/HFC blend (low GWP) | 50-75 kPa | 1600-2000 kPa | Modern commercial ice machines, cube and flake units, coldroom retrofits |
| R290 (propane) | Natural hydrocarbon (A3 flammable) | 30-50 kPa | 1000-1400 kPa | Undercounter and self-contained ice makers, nugget machines, back-bar units |
Common questions
Can a built-in Sub-Zero be repaired without removing the joinery in Broadacres?
In most cases yes. The units are designed to be serviced from the front through the grille and toe panel; full de-racking is only needed for sealed system work.
How long does a flake ice machine auger last?
On hard Johannesburg water an auger and gearbox typically run five to eight years. We check gearbox oil condition, bearing play and motor current at every service, because a worn water seal leaking into the gearbox is what usually kills the drive.
Do you charge a callout fee?
A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.