Board-level diagnostics for inverter heat pumps showing intermittent faults or poor COP. In Nelson Mandela Square this is sandton prime work on inverter heat pump systems, attended within about 35 minutes of dispatch.On York equipment specifically — commercial ducted, chillers and large air handling plant — the faults we see most in Nelson Mandela Square are control board relay failure and condenser fan contactor welding.Every visit starts with a full diagnostic and a written quote before any part is fitted.Centre management contractor permits; night work often required. Heat Pump Services bookings in Nelson Mandela Square are logged against Block 4 so we can allow for power availability on site.

Typical response window
35 minutes from Sandton
Distance from Sandton CBD
0.6 km
Municipal water hardness
moderate (140 ppm)
Load-shedding schedule
Block 4
Access & compliance
Centre management contractor permits; night work often required.
Typical installed systems
Restaurant coldrooms, display fridges and centralised HVAC.

Refrigerant data

GasClassificationSuction pressureDischarge pressureTypical use
R410aHFC blend (A1)280-320 kPa at 7 degrees C evaporating2 600-3 000 kPa at 45 degrees C ambientMost inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005.
R32HFC (A2L, mildly flammable)300-340 kPa at 7 degrees C evaporating2 700-3 100 kPa at 45 degrees C ambientCurrent-generation inverter splits and heat pumps.

Common questions

Can you work after trading hours?

Yes. Retail, restaurant and office work is routinely scheduled at night or early morning under a permit-to-work so trading is not interrupted.

Is a compressor replacement guaranteed?

Yes. Replacements are done with a system flush and new drier, and both part and workmanship are warranted, provided the original cause of failure is corrected.

How fast can you get to me?

Emergency callouts are dispatched to the next available technician, with the arrival window confirmed by SMS when the vehicle leaves.

Do you top up gas without finding the leak?

No. A weighed charge into a leaking system is money out the window, so the leak is found and repaired first, then the system is evacuated and charged to the plated weight.

Request a callout or quote

Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.