Repairs to upright and under-counter display fridges in restaurants, delis, bottle stores and coffee shops. In Hurlingham this is sandton prime work on display cabinet systems, attended within about 50 minutes of dispatch.On Defy equipment specifically — domestic double-door, side-by-side and chest freezers — the faults we see most in Hurlingham are defrost heater failure causing ice build-up and inverter compressor board faults.Every visit starts with a full diagnostic and a written quote before any part is fitted.Manor and estate sections require pre-booked access. Refrigeration Repairs bookings in Hurlingham are logged against Block 6 so we can allow for power availability on site.
- Typical response window
- 50 minutes from Sandton
- Distance from Sandton CBD
- 4.8 km
- Municipal water hardness
- moderate (140 ppm)
- Load-shedding schedule
- Block 6
- Access & compliance
- Manor and estate sections require pre-booked access.
- Typical installed systems
- Large stands, cellar cooling and pool heat pumps.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R134a | HFC (A1) | 80-140 kPa at -5 degrees C evaporating | 900-1 200 kPa at 45 degrees C ambient | Wine cellars, display cabinets, medium-temperature commercial refrigeration and some heat pumps. |
Common questions
Why is ice building up at the back of my Defy fridge in Hurlingham?
That is almost always a defrost circuit failure: the heater, bimetal or defrost sensor. The ice blocks the evaporator, airflow drops and the fridge compartment warms up while the compressor runs constantly.
Do you charge a callout fee?
A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.
How fast can you get to me?
Emergency callouts are dispatched to the next available technician, with the arrival window confirmed by SMS when the vehicle leaves.
Do you top up gas without finding the leak?
No. A weighed charge into a leaking system is money out the window, so the leak is found and repaired first, then the system is evacuated and charged to the plated weight.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.