Refrigeration Repairs in Hurlingham is handled as sandton prime work: large stands, cellar cooling and pool heat pumps. Technicians reach Hurlingham in roughly 50 minutes, 4.8 km from Sandton CBD.The work most often booked in this suburb is walk-in coldroom maintenance, freezer room repair, under-counter fridge repair. Wine cellars, luxury ducted aircon, high-end integrated fridges and domestic heat pumps.Manor and estate sections require pre-booked access. Water hardness in Hurlingham sits at moderate (140 ppm), which keeps scaling manageable but does not remove the need for an annual water-side check.Hurlingham falls in Block 6 for load-shedding, and repeated restarts on that schedule are the most common trigger behind inverter board and compressor failures we attend here, so surge protection is checked on every callout.

Typical response window
50 minutes from Sandton
Distance from Sandton CBD
4.8 km
Municipal water hardness
moderate (140 ppm)
Load-shedding schedule
Block 6
Access & compliance
Manor and estate sections require pre-booked access.
Typical installed systems
Large stands, cellar cooling and pool heat pumps.

Refrigerants we handle locally

GasClassificationSuction pressureDischarge pressureTypical use
R410aHFC blend (A1)280-320 kPa at 7 degrees C evaporating2 600-3 000 kPa at 45 degrees C ambientMost inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005.
R134aHFC (A1)80-140 kPa at -5 degrees C evaporating900-1 200 kPa at 45 degrees C ambientWine cellars, display cabinets, medium-temperature commercial refrigeration and some heat pumps.
R600aHydrocarbon (A3, flammable)20-60 kPa at -25 degrees C evaporating600-800 kPa at 45 degrees C ambientDomestic fridges, integrated columns and under-counter units.
R404AHFC blend (near-azeotropic)40-60 kPa (approx. 2-4 bar)1500-1900 kPaOlder commercial ice machines, cube makers, ice bins and blast chillers

Hurlingham questions, answered

Do you charge a callout fee?

A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.

My ice machine runs but makes no ice, is it worth repairing?

Usually yes. The four common causes (water inlet valve, water pump, scaled evaporator and a stalled harvest cycle) are all repairable at a fraction of replacement cost. We quote in writing after the diagnostic and tell you honestly when a machine is past economic repair.

Why is my ice cloudy or melting too fast?

Cloudy, soft ice means the freeze cycle is being cut short or the water is carrying too many dissolved solids. We test hardness and TDS on site, fit the right filtration, descale the plate and re-time the cycle so cubes freeze clear and hard.

Is scale really a problem for ice machines here?

Yes, it is the single biggest cause of lost output on this water supply. Scale insulates the evaporator, so the machine runs longer for less ice and eventually pits the plate. Regular descaling is far cheaper than an evaporator replacement.

Specific jobs in Hurlingham

Nearby areas

Request a callout or quote

Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.