Repairs to upright and under-counter display fridges in restaurants, delis, bottle stores and coffee shops. In Benmore Centre this is sandton prime work on display cabinet systems, attended within about 40 minutes of dispatch.On Sub-Zero equipment specifically — built-in refrigeration columns, wine storage and integrated units — the faults we see most in Benmore Centre are evaporator fan failure in freezer section and control board and sensor faults.Every visit starts with a full diagnostic and a written quote before any part is fitted.Centre management booking for roof and plant access. Refrigeration Repairs bookings in Benmore Centre are logged against Block 4 so we can allow for power availability on site.
- Typical response window
- 40 minutes from Sandton
- Distance from Sandton CBD
- 1.9 km
- Municipal water hardness
- moderate (140 ppm)
- Load-shedding schedule
- Block 4
- Access & compliance
- Centre management booking for roof and plant access.
- Typical installed systems
- Retail refrigeration and packaged rooftop HVAC.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R134a | HFC (A1) | 80-140 kPa at -5 degrees C evaporating | 900-1 200 kPa at 45 degrees C ambient | Wine cellars, display cabinets, medium-temperature commercial refrigeration and some heat pumps. |
Common questions
Can a built-in Sub-Zero be repaired without removing the joinery in Benmore Centre?
In most cases yes. The units are designed to be serviced from the front through the grille and toe panel; full de-racking is only needed for sealed system work.
Can you work after trading hours?
Yes. Retail, restaurant and office work is routinely scheduled at night or early morning under a permit-to-work so trading is not interrupted.
What does an annual service contract include?
Scheduled visits, priority response between visits, a written condition report per unit and fixed labour rates for the contract year.
Is a compressor replacement guaranteed?
Yes. Replacements are done with a system flush and new drier, and both part and workmanship are warranted, provided the original cause of failure is corrected.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.