Bar, scullery and kitchen island under-counter units repaired on site. In Norwood this is upper residential work on under-counter systems, attended within about 55 minutes of dispatch.On Sub-Zero equipment specifically — built-in refrigeration columns, wine storage and integrated units — the faults we see most in Norwood are evaporator fan failure in freezer section and control board and sensor faults.Every visit starts with a full diagnostic and a written quote before any part is fitted.Restaurant strip requires after-hours work. Refrigeration Repairs bookings in Norwood are logged against Block 8 so we can allow for power availability on site.

Typical response window
55 minutes from Rosebank & Parks Belt
Distance from Sandton CBD
10.9 km
Municipal water hardness
moderate (140 ppm)
Load-shedding schedule
Block 8
Access & compliance
Restaurant strip requires after-hours work.
Typical installed systems
Homes plus a dense restaurant refrigeration cluster.

Refrigerant data

GasClassificationSuction pressureDischarge pressureTypical use
R134aHFC (A1)80-140 kPa at -5 degrees C evaporating900-1 200 kPa at 45 degrees C ambientWine cellars, display cabinets, medium-temperature commercial refrigeration and some heat pumps.
R600aHydrocarbon (A3, flammable)20-60 kPa at -25 degrees C evaporating600-800 kPa at 45 degrees C ambientDomestic fridges, integrated columns and under-counter units.

Common questions

Can a built-in Sub-Zero be repaired without removing the joinery in Norwood?

In most cases yes. The units are designed to be serviced from the front through the grille and toe panel; full de-racking is only needed for sealed system work.

Do you charge a callout fee?

A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.

How fast can you get to me?

Emergency callouts are dispatched to the next available technician, with the arrival window confirmed by SMS when the vehicle leaves.

Do you top up gas without finding the leak?

No. A weighed charge into a leaking system is money out the window, so the leak is found and repaired first, then the system is evacuated and charged to the plated weight.

Request a callout or quote

Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.