Pressure testing, leak detection, vacuum and accurate weighed re-gas of R410a, R32 and legacy R22 systems. In Waterfall City this is corporate & commercial work on all split types systems, attended within about 55 minutes of dispatch.On Dunham-Bush equipment specifically — industrial chillers, fan coils and commercial hvac plant — the faults we see most in Waterfall City are chiller evaporator fouling and oil return problems on long pipe runs.Every visit starts with a full diagnostic and a written quote before any part is fitted.Precinct permit-to-work and building management escorts. Aircon Repairs & Servicing bookings in Waterfall City are logged against Block 15 so we can allow for power availability on site.
- Typical response window
- 55 minutes from Midrand & Waterfall Corridor
- Distance from Sandton CBD
- 13.5 km
- Municipal water hardness
- hard (180 ppm)
- Load-shedding schedule
- Block 15
- Access & compliance
- Precinct permit-to-work and building management escorts.
- Typical installed systems
- Corporate towers, retail and restaurants: chillers, VRF, coldrooms and display fridges.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R410a | HFC blend (A1) | 280-320 kPa at 7 degrees C evaporating | 2 600-3 000 kPa at 45 degrees C ambient | Most inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005. |
| R32 | HFC (A2L, mildly flammable) | 300-340 kPa at 7 degrees C evaporating | 2 700-3 100 kPa at 45 degrees C ambient | Current-generation inverter splits and heat pumps. |
| R22 | HCFC (phased out) | 480-520 kPa at 7 degrees C evaporating | 1 700-2 000 kPa at 45 degrees C ambient | Legacy splits and ducted plant installed before the phase-out. |
Common questions
How often should an aircon need re-gassing?
A correctly installed system should never need gas. If it does, there is a leak, so we pressure test and repair the leak before charging rather than topping up annually.
Can you work after trading hours?
Yes. Retail, restaurant and office work is routinely scheduled at night or early morning under a permit-to-work so trading is not interrupted.
What does an annual service contract include?
Scheduled visits, priority response between visits, a written condition report per unit and fixed labour rates for the contract year.
Is a compressor replacement guaranteed?
Yes. Replacements are done with a system flush and new drier, and both part and workmanship are warranted, provided the original cause of failure is corrected.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.