Pressure testing, leak detection, vacuum and accurate weighed re-gas of R410a, R32 and legacy R22 systems. In Noordwyk this is corporate & commercial work on all split types systems, attended within about 80 minutes of dispatch.On Samsung equipment specifically — wind-free splits, dvm s vrf and side-by-side refrigeration — the faults we see most in Noordwyk are ice build-up on evaporator in french-door fridges and indoor display board comms loss.Every visit starts with a full diagnostic and a written quote before any part is fitted.Standard complex access. Aircon Repairs & Servicing bookings in Noordwyk are logged against Block 16 so we can allow for power availability on site.
- Typical response window
- 80 minutes from Midrand & Waterfall Corridor
- Distance from Sandton CBD
- 20 km
- Municipal water hardness
- hard (200 ppm)
- Load-shedding schedule
- Block 16
- Access & compliance
- Standard complex access.
- Typical installed systems
- Complexes with midwall splits.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R410a | HFC blend (A1) | 280-320 kPa at 7 degrees C evaporating | 2 600-3 000 kPa at 45 degrees C ambient | Most inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005. |
| R32 | HFC (A2L, mildly flammable) | 300-340 kPa at 7 degrees C evaporating | 2 700-3 100 kPa at 45 degrees C ambient | Current-generation inverter splits and heat pumps. |
| R22 | HCFC (phased out) | 480-520 kPa at 7 degrees C evaporating | 1 700-2 000 kPa at 45 degrees C ambient | Legacy splits and ducted plant installed before the phase-out. |
Common questions
What does an E1 or E4 error mean on a Samsung aircon in Noordwyk?
E1 is a room temperature sensor error and E4 is an evaporator sensor error. Both are usually a failed thermistor or a connector that has corroded on the indoor board, and both are inexpensive parts once the correct one is identified.
How often should an aircon need re-gassing?
A correctly installed system should never need gas. If it does, there is a leak, so we pressure test and repair the leak before charging rather than topping up annually.
Do you charge a callout fee?
A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.