Full preventative service: coil clean, filter replacement, drain flush, gas pressure check and electrical torque test. In Sandhurst this is sandton prime work on midwall split systems, attended within about 45 minutes of dispatch.On Daikin equipment specifically — inverter splits, vrv multi-storey systems and ducted plant — the faults we see most in Sandhurst are outdoor pcb failure after surge events and eev coil sticking on multi-splits.Every visit starts with a full diagnostic and a written quote before any part is fitted.Private security estate rules; most homes require boom-gate clearance and a scheduled arrival window. Aircon Repairs & Servicing bookings in Sandhurst are logged against Block 4 so we can allow for power availability on site.
- Typical response window
- 45 minutes from Sandton
- Distance from Sandton CBD
- 1.5 km
- Municipal water hardness
- moderate (140 ppm)
- Load-shedding schedule
- Block 4
- Access & compliance
- Private security estate rules; most homes require boom-gate clearance and a scheduled arrival window.
- Typical installed systems
- Large single-stand homes with ducted central plant, wine cellars and integrated appliance columns.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R410a | HFC blend (A1) | 280-320 kPa at 7 degrees C evaporating | 2 600-3 000 kPa at 45 degrees C ambient | Most inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005. |
| R32 | HFC (A2L, mildly flammable) | 300-340 kPa at 7 degrees C evaporating | 2 700-3 100 kPa at 45 degrees C ambient | Current-generation inverter splits and heat pumps. |
| R22 | HCFC (phased out) | 480-520 kPa at 7 degrees C evaporating | 1 700-2 000 kPa at 45 degrees C ambient | Legacy splits and ducted plant installed before the phase-out. |
Common questions
Why is my Daikin unit flashing its indicator light in Sandhurst?
A flashing operation lamp means the board has logged a fault code. Pressing the cancel button on the remote and holding it cycles the code out; U0 points to a low charge, U4 to a communication fault between indoor and outdoor units, and A5 to a freeze or high pressure trip.
Do you charge a callout fee?
A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.
What does an annual service contract include?
Scheduled visits, priority response between visits, a written condition report per unit and fixed labour rates for the contract year.
Is a compressor replacement guaranteed?
Yes. Replacements are done with a system flush and new drier, and both part and workmanship are warranted, provided the original cause of failure is corrected.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.