Full preventative service: coil clean, filter replacement, drain flush, gas pressure check and electrical torque test. In Parktown this is upper residential work on midwall split systems, attended within about 55 minutes of dispatch.On York equipment specifically — commercial ducted, chillers and large air handling plant — the faults we see most in Parktown are condenser fan contactor welding and low charge causing high superheat.Every visit starts with a full diagnostic and a written quote before any part is fitted.Institutional and medical buildings need permit-to-work. Aircon Repairs & Servicing bookings in Parktown are logged against Block 8 so we can allow for power availability on site.
- Typical response window
- 55 minutes from Rosebank & Parks Belt
- Distance from Sandton CBD
- 10.4 km
- Municipal water hardness
- moderate (135 ppm)
- Load-shedding schedule
- Block 8
- Access & compliance
- Institutional and medical buildings need permit-to-work.
- Typical installed systems
- Medical suites and offices with central HVAC and specimen refrigeration.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R410a | HFC blend (A1) | 280-320 kPa at 7 degrees C evaporating | 2 600-3 000 kPa at 45 degrees C ambient | Most inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005. |
| R32 | HFC (A2L, mildly flammable) | 300-340 kPa at 7 degrees C evaporating | 2 700-3 100 kPa at 45 degrees C ambient | Current-generation inverter splits and heat pumps. |
| R22 | HCFC (phased out) | 480-520 kPa at 7 degrees C evaporating | 1 700-2 000 kPa at 45 degrees C ambient | Legacy splits and ducted plant installed before the phase-out. |
Common questions
Can you work after trading hours?
Yes. Retail, restaurant and office work is routinely scheduled at night or early morning under a permit-to-work so trading is not interrupted.
Is a compressor replacement guaranteed?
Yes. Replacements are done with a system flush and new drier, and both part and workmanship are warranted, provided the original cause of failure is corrected.
How fast can you get to me?
Emergency callouts are dispatched to the next available technician, with the arrival window confirmed by SMS when the vehicle leaves.
Do you top up gas without finding the leak?
No. A weighed charge into a leaking system is money out the window, so the leak is found and repaired first, then the system is evacuated and charged to the plated weight.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.