Pressure testing, leak detection, vacuum and accurate weighed re-gas of R410a, R32 and legacy R22 systems. In Greenside this is upper residential work on all split types systems, attended within about 55 minutes of dispatch.On Dunham-Bush equipment specifically — industrial chillers, fan coils and commercial hvac plant — the faults we see most in Greenside are compressor contactor failure and chiller evaporator fouling.Every visit starts with a full diagnostic and a written quote before any part is fitted.Mixed residential and restaurant strip access. Aircon Repairs & Servicing bookings in Greenside are logged against Block 7 so we can allow for power availability on site.

Typical response window
55 minutes from Rosebank & Parks Belt
Distance from Sandton CBD
9.4 km
Municipal water hardness
moderate (140 ppm)
Load-shedding schedule
Block 7
Access & compliance
Mixed residential and restaurant strip access.
Typical installed systems
Homes plus restaurant refrigeration on the Gleneagles strip.

Refrigerant data

GasClassificationSuction pressureDischarge pressureTypical use
R410aHFC blend (A1)280-320 kPa at 7 degrees C evaporating2 600-3 000 kPa at 45 degrees C ambientMost inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005.
R32HFC (A2L, mildly flammable)300-340 kPa at 7 degrees C evaporating2 700-3 100 kPa at 45 degrees C ambientCurrent-generation inverter splits and heat pumps.
R22HCFC (phased out)480-520 kPa at 7 degrees C evaporating1 700-2 000 kPa at 45 degrees C ambientLegacy splits and ducted plant installed before the phase-out.

Common questions

How often should an aircon need re-gassing?

A correctly installed system should never need gas. If it does, there is a leak, so we pressure test and repair the leak before charging rather than topping up annually.

Do you charge a callout fee?

A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.

How fast can you get to me?

Emergency callouts are dispatched to the next available technician, with the arrival window confirmed by SMS when the vehicle leaves.

Do you top up gas without finding the leak?

No. A weighed charge into a leaking system is money out the window, so the leak is found and repaired first, then the system is evacuated and charged to the plated weight.

Request a callout or quote

Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.