Full preventative service: coil clean, filter replacement, drain flush, gas pressure check and electrical torque test. In Paulshof this is luxury gated estates work on midwall split systems, attended within about 60 minutes of dispatch.On Midea equipment specifically — value inverter splits, cassettes and hot water heat pumps — the faults we see most in Paulshof are four-way valve sticking in heating mode and outdoor fan capacitor failure.Every visit starts with a full diagnostic and a written quote before any part is fitted.Complex access via intercom; some HOAs restrict drilling hours. Aircon Repairs & Servicing bookings in Paulshof are logged against Block 11 so we can allow for power availability on site.
- Typical response window
- 60 minutes from Fourways & Northern Suburbs
- Distance from Sandton CBD
- 10.8 km
- Municipal water hardness
- moderate (170 ppm)
- Load-shedding schedule
- Block 11
- Access & compliance
- Complex access via intercom; some HOAs restrict drilling hours.
- Typical installed systems
- Townhouses and family homes, high heat pump geyser retrofit rate.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R410a | HFC blend (A1) | 280-320 kPa at 7 degrees C evaporating | 2 600-3 000 kPa at 45 degrees C ambient | Most inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005. |
| R32 | HFC (A2L, mildly flammable) | 300-340 kPa at 7 degrees C evaporating | 2 700-3 100 kPa at 45 degrees C ambient | Current-generation inverter splits and heat pumps. |
| R22 | HCFC (phased out) | 480-520 kPa at 7 degrees C evaporating | 1 700-2 000 kPa at 45 degrees C ambient | Legacy splits and ducted plant installed before the phase-out. |
Common questions
My Midea unit heats but will not cool. What is wrong in Paulshof?
That points to the four-way reversing valve sticking or its solenoid coil failing. It can often be freed and the coil replaced without opening the sealed system.
Do you charge a callout fee?
A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.
There is water on the floor under my ice machine, can you find the leak?
We trace it wet rather than guessing: inlet valve weep, split distribution tube, blocked machine drain or a backed-up bin drain all present the same way. The water side is pressure-tested before we recommission.
How urgent is a slow harvest cycle?
Treat it as urgent. A stalling harvest leaves the plate frozen solid, output collapses and the compressor runs against high head pressure, which is how a cheap solenoid fault turns into a compressor replacement.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.