Full preventative service: coil clean, filter replacement, drain flush, gas pressure check and electrical torque test. In Design Quarter this is luxury gated estates work on midwall split systems, attended within about 60 minutes of dispatch.On LG equipment specifically — dual inverter splits, multi v vrf and instaview refrigeration — the faults we see most in Design Quarter are blocked drain causing indoor water leaks and linear compressor failure on refrigerators.Every visit starts with a full diagnostic and a written quote before any part is fitted.Tenant and centre coordination for shared plant. Aircon Repairs & Servicing bookings in Design Quarter are logged against Block 12 so we can allow for power availability on site.
- Typical response window
- 60 minutes from Fourways & Northern Suburbs
- Distance from Sandton CBD
- 13 km
- Municipal water hardness
- hard (185 ppm)
- Load-shedding schedule
- Block 12
- Access & compliance
- Tenant and centre coordination for shared plant.
- Typical installed systems
- Restaurant and showroom cooling.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R410a | HFC blend (A1) | 280-320 kPa at 7 degrees C evaporating | 2 600-3 000 kPa at 45 degrees C ambient | Most inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005. |
| R32 | HFC (A2L, mildly flammable) | 300-340 kPa at 7 degrees C evaporating | 2 700-3 100 kPa at 45 degrees C ambient | Current-generation inverter splits and heat pumps. |
| R22 | HCFC (phased out) | 480-520 kPa at 7 degrees C evaporating | 1 700-2 000 kPa at 45 degrees C ambient | Legacy splits and ducted plant installed before the phase-out. |
Common questions
Is an LG linear compressor worth repairing in Design Quarter?
On refrigerators still within their ten-year sealed system warranty, yes. Outside it, we quote the compressor and drier replacement against the value of the unit so you can decide on the numbers rather than a guess.
Can you work after trading hours?
Yes. Retail, restaurant and office work is routinely scheduled at night or early morning under a permit-to-work so trading is not interrupted.
My ice machine runs but makes no ice, is it worth repairing?
Usually yes. The four common causes (water inlet valve, water pump, scaled evaporator and a stalled harvest cycle) are all repairable at a fraction of replacement cost. We quote in writing after the diagnostic and tell you honestly when a machine is past economic repair.
Why is my ice cloudy or melting too fast?
Cloudy, soft ice means the freeze cycle is being cut short or the water is carrying too many dissolved solids. We test hardness and TDS on site, fit the right filtration, descale the plate and re-time the cycle so cubes freeze clear and hard.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.