Full preventative service: coil clean, filter replacement, drain flush, gas pressure check and electrical torque test. In Chartwell this is luxury gated estates work on midwall split systems, attended within about 80 minutes of dispatch.We work across every major brand installed in Chartwell, and diagnostics start from the plated design data rather than a guess.Correctly sized, correctly sited installation with commissioning readings recorded and warranty registered.Smallholdings with long driveways; borehole water common. Aircon Repairs & Servicing bookings in Chartwell are logged against Block 14 so we can allow for power availability on site.
- Typical response window
- 80 minutes from Fourways & Northern Suburbs
- Distance from Sandton CBD
- 18.5 km
- Municipal water hardness
- hard (205 ppm)
- Load-shedding schedule
- Block 14
- Access & compliance
- Smallholdings with long driveways; borehole water common.
- Typical installed systems
- Smallholdings with multiple standalone systems and borehole-fed hot water.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R410a | HFC blend (A1) | 280-320 kPa at 7 degrees C evaporating | 2 600-3 000 kPa at 45 degrees C ambient | Most inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005. |
| R32 | HFC (A2L, mildly flammable) | 300-340 kPa at 7 degrees C evaporating | 2 700-3 100 kPa at 45 degrees C ambient | Current-generation inverter splits and heat pumps. |
| R22 | HCFC (phased out) | 480-520 kPa at 7 degrees C evaporating | 1 700-2 000 kPa at 45 degrees C ambient | Legacy splits and ducted plant installed before the phase-out. |
Common questions
Do you charge a callout fee?
A standard callout and diagnostic fee applies and is quoted upfront. It is credited against the repair when you accept the quote.
Why is my ice cloudy or melting too fast?
Cloudy, soft ice means the freeze cycle is being cut short or the water is carrying too many dissolved solids. We test hardness and TDS on site, fit the right filtration, descale the plate and re-time the cycle so cubes freeze clear and hard.
Is scale really a problem for ice machines here?
Yes, it is the single biggest cause of lost output on this water supply. Scale insulates the evaporator, so the machine runs longer for less ice and eventually pits the plate. Regular descaling is far cheaper than an evaporator replacement.
There is water on the floor under my ice machine, can you find the leak?
We trace it wet rather than guessing: inlet valve weep, split distribution tube, blocked machine drain or a backed-up bin drain all present the same way. The water side is pressure-tested before we recommission.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.