Full preventative service: coil clean, filter replacement, drain flush, gas pressure check and electrical torque test. In Blair Atholl this is luxury gated estates work on midwall split systems, attended within about 85 minutes of dispatch.We work across every major brand installed in Blair Atholl, and diagnostics start from the plated design data rather than a guess.Compressor swaps are done with a full system flush, new drier and an oil-charge check so the replacement is not killed by the original contamination.Gated golf estate with contractor accreditation and limited daily entry slots. Aircon Repairs & Servicing bookings in Blair Atholl are logged against Block 14 so we can allow for power availability on site.
- Typical response window
- 85 minutes from Fourways & Northern Suburbs
- Distance from Sandton CBD
- 24 km
- Municipal water hardness
- hard (215 ppm)
- Load-shedding schedule
- Block 14
- Access & compliance
- Gated golf estate with contractor accreditation and limited daily entry slots.
- Typical installed systems
- Very large homes on ducted plant with pool and hot water heat pumps.
Refrigerant data
| Gas | Classification | Suction pressure | Discharge pressure | Typical use |
|---|---|---|---|---|
| R410a | HFC blend (A1) | 280-320 kPa at 7 degrees C evaporating | 2 600-3 000 kPa at 45 degrees C ambient | Most inverter splits, ducted systems, VRV/VRF and heat pumps installed since 2005. |
| R32 | HFC (A2L, mildly flammable) | 300-340 kPa at 7 degrees C evaporating | 2 700-3 100 kPa at 45 degrees C ambient | Current-generation inverter splits and heat pumps. |
| R22 | HCFC (phased out) | 480-520 kPa at 7 degrees C evaporating | 1 700-2 000 kPa at 45 degrees C ambient | Legacy splits and ducted plant installed before the phase-out. |
Common questions
Is a compressor replacement guaranteed?
Yes. Replacements are done with a system flush and new drier, and both part and workmanship are warranted, provided the original cause of failure is corrected.
Do you work inside gated estates?
Regularly. Technician details, ID numbers and vehicle registration are submitted to the HOA or gatehouse before the appointment so access is cleared in advance.
Is scale really a problem for ice machines here?
Yes, it is the single biggest cause of lost output on this water supply. Scale insulates the evaporator, so the machine runs longer for less ice and eventually pits the plate. Regular descaling is far cheaper than an evaporator replacement.
There is water on the floor under my ice machine, can you find the leak?
We trace it wet rather than guessing: inlet valve weep, split distribution tube, blocked machine drain or a backed-up bin drain all present the same way. The water side is pressure-tested before we recommission.
Request a callout or quote
Send it straight to our WhatsApp for the fastest response, or call 069 268 0988 / email info@reyds.co.za.